Today’s project is a little different to my usual sewing projects and its actually my first ever home make! I have officially welcomed the envelope pillow into my repertoire. My partner’s mum bought us some towels and a beautiful throw so I wanted to make something nice for her and I decided on a throw pillow. She actually gave me some beautiful homefurnishing fabric that she bought when she was redoing their house. She loved the fabric but wasn’t sure what to use it for so I thought I would make her an envelope pillow.
Envelope pillows are a really simple make, it took me an hour maybe an hour and a half at most. The longest part was waiting for the pad to arrive! I didn’t use a pattern, I just took measurements and went with it. Its honestly the easiest make and I would encourage anyone, particularly beginners to have a go.
Step 1 – Measure Up
Select the size of pillow you want to make. Either choose a pillow pad or measure an existing one if you looking to refresh an existing cushion. Take the measurement of the length and width of the pillow with a cloth measuring tape and ensure to measure including the curve of the pillow. Then add an inch at both ends of each measurement and mark out your square or rectangle on your fabric with tailors chalk.
Step 2 – Cut Your Three Pieces
When cutting upholstery or home-furnishing fabric I tend to use pinking shears as they have a bit more bite and stop fraying. To make the pillow you need three pieces.
- 1 x square (or rectangle) to the measurements from above.
- 2 x rectangular pieces the same width and approximately two thirds the length of the main square with at least a 4cm overlap.
To ensure the pieces fit lay them carefully on top of each other as you will sew them and make sure the outside edges match.
Step 3 – Finish the Envelope Edges
In order to create a nice finish on your pillow you are going to want to finish the two overlapping edges on the back. To finish the edges fold it over by 1/8inch and stitch and then do the same again.
Step 4 – Pin Together and Sew
Pin the pieces right side together and stitch along the outside edge with 1/2 inch seam allowance. Stitch continuously around the square and then press.
Step 5 – Clip Corners and Turn Out
Finally clip the corners and turn right side out. I turned my corners out using a biro with its lid on but a knitting needle, chopstick or anything else with a blunt point will do. Press once more and then voila, you’re done!